High Solids Productive Epoxy Primer – Corlar 2.1 PR-P

Référence Corlar 2.1 PR-P

Description

A high solid, two component, high build, VOC conforming (2.1 lbs./gal.) Low HAPS productive primer based on Axalta modified polyamide epoxy technology. The resulting
primer is formulated to be highly durable with very fast dry times and to deliver excellent corrosion and chemical resistance.

Suggested uses

As a highly durable primer on properly prepared carbon steel, galvanized steel, stainless steel and aluminum where:
• Recoating in 30 minutes is required for maximum productivity.
• No induction time and long pot life will improve productivity.
• A smooth, sand-able primer at 3 mils DFT for maximum appearance when top coated is required.
• Application by brush and roller, in addition to spraying, may be necessary.
• Spray application with minimal dry spray is desired.
• Application at temperatures as low as 35°F.
• As a high build primer when using FG-042 High Build Activator.
Corlar 2.1 PR-P is intended to be used as a primer and should be top coated.

Compatibility with other coatings

• Corlar 2.1 PR-P is highly compatible with most coating types. It may be used over most aged and hard cured coatings in good condition. Testing for lifting, bubbling and adhesion
is recommended to assure compatibility with unknown coatings. Contact your Axalta representative for specific recommendations.

Not recommended for

• Immersion service
• Large areas with surface temperatures higher than 85°F. (See additional note under application section.)

Performance properties

(with appropriate topcoat)
Alkalis Excellent
Solvents Excellent
Acids Very Good
Humidity Excellent
Weather Excellent (will chalk if left untopcoated)

Color

525-880™ Red Oxide
525-886™ Black
525-882™ Buff
525-971™ ANSI 70 Grey 525-885™ ANSI 61 Grey 525-968™ White